Ways to improve the abnormal automatic back glue machine:

　　1. Abnormal material processing: The customer's incoming material belt is bad, and the knife is too deep during material processing, which will punch through the material belt, affecting the discharge and retrieving of materials;

　　Improvement method: Advise the customer to communicate with the processor, adjust the depth of the knife, and prevent the tape from being pierced

　　2. The selection of the material belt is abnormal: the viscosity of the incoming material is too high, it cannot be peeled off, and the output is abnormal;

　　Improvement method: It is recommended to replace the material tape with higher release strength, and some materials are evaluated to replace the thin paper tape

　　The above are only some common problems and solutions of smt automatic back glue machine